Switch-M24eGi(PN28240i) Release Note

April 14, 2025 Version 3.0.0.07
- Resolved Issues:
1.When the loop detection function is in shutdown mode, the port shutdown is cleared due to the elapse of the recovery time even if the loop fault continues.
2.The LACP received from other devices at port with link aggregation disabled is forwarded.


July 5, 2024: Version 3.0.0.06
- Specification Changes:
1.System log / SNMP trap issuance delay time setting command.
 logtrap linkchange delay <0-30>

- Resolved Issues:
1.Operation becomes unstable when certain SNMP packets are received.


October 7, 2021 Version 3.0.0.03
- Resolved Issues:
1. If you configure "dot1x control-direction in", receiving packets are forword to other ports even though the port is not authenticated.


June 11, 2021: Version 3.0.0.02
- Specification Changes:
1.The default value of Energy Efficient Ethernet (EEE) has been changed to Disable.

- Resolved Issues:
1.When setting the threshold value of a storm control on the menu, the value is set to 0 after you press "Enter" without entering a (numerical) value.
2.The timing to implement an optimization of a file system 
3.On the port (before authenticating the WEB) where the WEB authentication is enabled, obtaining an IP address through DHCP results in a failure.  
4.A specific IP address cannot be set to a default gateway. 
5.When the connection with an SNTP server is not available, CLI does not respond after you execute the "sntp update hcommand. 

-Note
You update to firmware version 3.0.0.02 or later, the Energy Efficient Ethernet (EEE) settings will be Disable.
If you want to operate with EEE settings Enable, update to firmware version 3.0.0.02 or later and then enable EEE settings.


October 1, 2019: Version 3.0.0.00
First release.